Product Description
KRX Tender Spring Installation Instructions
NOTE FINAL SETTING IS THE RIDE HEIGHT SETTING NOT YOUR PRE LOAD!!!!!!!!!!!!!
****All machines possibly weigh different because of personalized accessories*********************
Tender spring installation instructions
- Secure machine in Park. And then measure front ride height at forward lower a arm mount, then record. Then measure rear ride height right below the tow hook, and record.
- Lube and clean threads on all shocks with wire brush and WD40 type lube.
- Lift the front of the machine and remove the shocks and put shock in vice upside down. Now with shock removed and in vice loosen the large top spanner nut utilizing the teeth. Loosen nut all the way to reservoir. Remove lower coupler and remove springs. Add new tender springs and reinstall the lower spring retainer utilizing the rented spring compressor. Tighten spanner nut down 3 inches from black shock cap (where aluminum ends). Re install shocks tighten shock bolts move machine forward or backward 5-6 feet to settle front and then set your ride height to listed recommendations below. Tightening the spanner down will raise the machine , loosening the spanner toward top will lower machine. Fine tuning is necessary because all machines are outfitted with different accessories and weigh different.
Rear Tender Install
- Secure machine in Park. And then measure front ride height at forward lower a arm mount, then record. Then measure rear ride height right below the tow hook, and record.
- Lube and clean threads on all shocks with wire brush and WD40 type lube.
- You do not have to completely remove
- Remove wheel loosen the top spanner nut and then you can spin the springs to get them loose enough to remove lower retainer. Once loose you can then remove te lower shock bolt only. The top bolt can stay tight and torqued.
- Slide springs off the bottom of the shock.
- Install tender springs first and then main springs. Reinstall lower shock bolt and torque
- Move spanner down adding 1 inch or preload.
- Reinstall wheel and remove machine from jack. Drive machine forward or backward 5-6 feet allowing the suspension to settle.
- Now run the spanner down to achieve recommended ride height.
Recommended ride height measured from the skid plate in the center of the front diff, and the rear is measured from skid plate at center of rear near tow hook
Tire size ride height
31in 14.5 Front 14 rear
Tire size ride height
32 in 15front 14.5 rear
33 in 15.5 front and 15 rear
35 in 16.5 front and 16 rear
On some instances you may need to utilize a spring compressor. If a compressor is needed you can borrow them from your local parts store.
Springs are labeled with location to where they need to be placed.
As a side note: kit may make noise or cause wear, as you are adding items that are not factory. All these things are normal and will cause no issues what so ever.
Always remember when towing/trailering your machine to secure machine over the tires, so springs aren’t potentially damaged. Please check out the website for all of your Polaris RZR needs